1.Decoiler：passive feeding，manual tightening
2.Rated load of decoiler：5T
3.Diameter of shaft: ￠60㎜
4.Main motor power：5.5 kw
5.Linear speed： 10m/min
6.Roll stand：17 horizontal roller and a series of vertical roller
7.Material of roller：45# forging steel
8.Surface of roller: with chrome, single side 0.05mm
9.Raw material specification：color steel sheet
10.Thickness：0.5-0.6mm
11.Motor of hydraulic station：3kw
12.Hydraulic oil pump：gear pump CB-E314
13.Material of cutter blade：Cr12
14.Quenching hardness of cutter blade：HRC580-620
15.Cutting method：Mould cutting after forming
16.Length tolerance：±2mm
17.Transducer: Halip (Danfoss)
18.Computer: PLC, Omron
19.Computer operating board adopts OP320A, Thinget